Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tremron Kitchen Remodeling: The Santa Clarita Owner’s Guide
Tremron kitchen remodeling in Santa Clarita typically runs $14,000-$45,000 installed, depending on scope, material grade, and whether we’re working with existing Tremron pavers, hardscape elements, or coordinating Tremron surfaces with new cabinetry and countertops. We stock Tremron-compatible installation materials and can usually begin material procurement within 24-48 hours of a signed agreement. Most Santa Clarita homeowners discover their Tremron installation needs attention when they notice settling in outdoor kitchen pavers, staining that won’t clean off the hardscape surface, or separation between the Tremron hardscape and the indoor kitchen transition during our initial walkthrough.
Which Tremron Models This Applies To
Tremron manufactures several product lines that integrate with kitchen remodeling projects in Santa Clarita, primarily their Olde Towne, Autumn Blend, and Sierra paver series used for outdoor kitchen flooring, patio transitions, and built-in grill pad installations. The identifying mark is stamped on the paver edge or printed on the original invoice: a four-digit batch code starting with “TR-” followed by the year of manufacture. Pre-2018 Tremron pavers used a different edge profile (slightly beveled, 3/16 inch) than current production (micro-chamfered, 1/16 inch), which affects how new material butts against existing when we’re doing a partial replacement.
We source Tremron through authorized distributors in the San Fernando Valley, not big-box retail, which means we get the correct color lot matching and the manufacturer’s spec sheet for freeze-thaw rating. That’s relevant in Santa Clarita because the temperature swing between August afternoons and January nights can exceed 50 degrees, and not every paver rated for Florida humidity handles that cycle. For outdoor kitchen applications, we specify Tremron’s 60mm thickness minimum; the 45mm residential-grade pavers will crack under the point load of a built-in grill or pizza oven base. If your original installer used 45mm, that’s likely why you’re reading this page.
Rowan Construction Group Santa Clarita is an independent service provider and not affiliated with Tremron.
Signs Your Tremron Kitchen Remodeling Is Failing

- Pavers settling or rocking underfoot near the grill or sink. This usually means the bedding sand has washed out from improper edge restraint or missing polymeric sand in the joints. In Santa Clarita’s flash-flood rain pattern, water finds any gap and erodes the base within two to three seasons.
- White haze or efflorescence that returns after cleaning. This is mineral salts migrating through the paver body, common with Tremron’s lighter color blends installed without a vapor barrier over expansive clay soil. Stevenson Ranch and Sand Canyon properties see this more than flatland Santa Clarita homes.
- Chipping at the paver edges, especially in the traffic path between indoor and outdoor kitchen. The cause is almost always the wrong thickness for the application, or a base that wasn’t compacted to 98% standard Proctor density before laying. We check this with a nuclear density gauge before we quote.
- Stains that darken after rain and won’t lift with pressure washing. Oil from the grill, citrus from outdoor prep, or fertilizer from adjacent planters has penetrated the paver surface. Tremron’s denser color blends resist this better than the more porous earth tones, which is a specification detail the original installer should have discussed.
- Gap widening between the Tremron field and the house slab or stucco. Santa Clarita’s adobe and clay soils expand and contract with moisture. Without an adequate expansion joint (minimum 1/2 inch with backer rod and flexible sealant), the pavers push against the structure and either crack or separate.
Before
AfterReplacement Cost & What’s Included
| Scope | Price Range in Santa Clarita |
|---|---|
| Partial Tremron paver replacement (outdoor kitchen pad, up to 100 sq ft) | $2,000-$5,500 |
| Full outdoor kitchen hardscape with Tremron pavers (200-400 sq ft) | $7,000-$14,000 |
| Integrated indoor-outdoor kitchen remodel with Tremron transition | $14,000-$45,000 |
| Base repair/rebuild under existing Tremron (labor only, no new pavers) | $1,500-$4,000 |
The range depends on three factors: whether we can match the existing Tremron color lot (discontinued blends require full-area replacement), how much base repair is needed after we lift the failed section, and whether the project scope includes coordinating with new cabinetry, countertops, or appliance rough-ins. We itemize every line in the written quote: demolition, base material and compaction, paver cost per square foot, edge restraint, polymeric sand, sealant, and labor by the day. Under Clause 1 of The Haven Standard, that written price is the price. No change proceeds without a signed change order, which is why our projects finish within a few percent of the number we agreed on.
Every Tremron installation we touch carries our 365-Day Done Right Promise. If the pavers settle, the joints wash out, or the sealant fails because of something we did or specified, we make it right without a service call charge.
DIY or Call Us?

There’s a short list of things a Santa Clarita homeowner can safely check without calling us: verify the paver batch code from your original paperwork, measure the settled area with a tape, and photograph the failure pattern from multiple angles. That documentation helps us quote accurately before we drive out.
What doesn’t work as DIY: lifting settled pavers without checking why they settled. If the base is eroded, dropping new sand underneath and tapping them back down buys you one season before they’re rocking again. Compacting the base properly requires a plate compactor (rental is $80-$120 per day in Santa Clarita) and the judgment to know when the moisture content is right for compaction. Too dry and you get bridging; too wet and you get pumping. We’ve both seen. Cutting pavers for the edge pattern requires a wet saw with a diamond blade; the rental unit from the hardware store will cut, but the dust control is minimal and the cut quality shows. For integrated indoor-outdoor kitchens, there’s also the matter of matching the finished floor elevation so you don’t trip every time you carry a platter outside.
Call (747) 294-3985 when you’re ready for a written quote. We’ll bring color samples, check the base with our gauge, and give you a price that doesn’t change unless you change the scope.
FAQs
Properly installed Tremron pavers with the correct base and edge restraint last 25-30 years in Santa Clarita’s climate. The failure point is almost always the installation, not the material: inadequate base depth (we specify 6-8 inches of Class II road base for pedestrian loads, 10-12 inches for grill pads), missing edge restraint, or skipping the geotextile fabric over clay soils. Call (747) 294-3985 for an exact quote on your specific installation - estimates are free.
Individual pavers can be lifted and reinstalled if the base is sound and the paver itself isn’t cracked. We do this when the failure is isolated joint washout or a single sunken area. If the color lot is discontinued or the efflorescence has permanently altered the surface chemistry, replacement of the affected field is the only fix that looks right. Call (747) 294-3985 and we’ll tell you which category you’re in after a 15-minute look.
A partial outdoor kitchen hardscape repair takes 2-3 days. A full indoor-outdoor kitchen remodel with Tremron integration runs 4-8 weeks, depending on cabinet lead time (KraftMaid and Wellborn both quote 4-6 weeks currently) and whether we’re coordinating countertop templating with Cambria or Silestone. We build a critical-path schedule before we start and update it weekly. Call (747) 294-3985 to schedule your free estimate.
We don’t stock Tremron pavers in our warehouse; color matching requires ordering from the current production lot, which typically delivers to our Santa Clarita staging area within 5-7 business days. We do stock the base materials, edge restraints, polymeric sands, and sealants specific to Tremron’s recommended installation system, so work starts the day after pavers arrive. For urgent situations, we can sometimes pull matching material from regional distributor inventory in 48 hours. Call (747) 294-3985 to check current availability.
We also stock and install parts for KraftMaid, Cambria, and Silestone.
Written by Grant Rowan, Owner, Rowan Construction Group Santa Clarita at Rowan Construction Group Santa Clarita, serving Santa Clarita and nearby areas.







Before
After
Before
After