Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Boral Fence Installation: The Santa Clarita Owner’s Guide
Boral fence installation in Santa Clarita typically runs $3,500-$9,000 for a complete residential system, depending on linear footage, grade conditions, and whether you’re matching an existing Boral panel style. We stock Boral-compatible posts, rails, and infill panels for same-day starts on most standard heights. Most Santa Clarita homeowners discover their Boral fence needs attention when posts lean after winter rains undermine the footing, or when powder-coated aluminum rails start chalking from the valley’s intense UV exposure.
Which Boral Models This Applies To
Boral’s fencing line in the California market centers on powder-coated aluminum systems, not the masonry products the name sometimes suggests. The two series you’re most likely to encounter in Santa Clarita are the Boral Classic line, with its 2-inch rail profile and snap-lock picket design, and the heavier Boral Estate series, which uses a 3-inch rail and concealed fasteners for a cleaner sight line. Check the inside face of your end post for a stamped series mark, usually 6 inches above grade, or measure your top rail: 2 inches indicates Classic, 3 inches indicates Estate.
The critical compatibility gotcha is post spacing. Boral Classic is engineered for 6-foot centers; stretch that to 8 feet to save on posts and the rail will sag within two Santa Clarita summers. Estate handles 8-foot centers, but only with the heavier 0.080-inch wall posts, not the 0.060-inch retail-grade version some box stores carried in 2018-2020. We source direct from Boral’s Western distribution center in Fontana, so we match OEM specs exactly. For discontinued Classic colors like Desert Sand, we can often source quality-matched aftermarket powder coat through our Santa Clarita finishing partner, though we note the origin in writing before you decide.
Signs Your Boral Fence Installation Is Failing

- Posts lean or wobble at the base. The concrete footing has cracked or washed out, common in Santa Clarita’s sandy loam after repeated irrigation or the brief but intense winter rains we get. The post itself may be sound, but the footing diameter was likely too small for the wind load.
- Rail ends have pulled from the post pockets. Thermal expansion in Santa Clarita’s 100-plus-degree summer cycles causes aluminum to grow roughly 1/8 inch per 10 feet of rail. If the installer didn’t leave expansion room in the pocket, the rail end crimps or the post ear cracks.
- Picket tops show white chalking or color shift. The polyester powder coat has UV-degraded. Boral’s standard finish carries a 10-year chalk rating; in Santa Clarita’s high-UV zone, visible chalking often appears at year 7-9, sooner if the fence faces southwest.
- Gates drag or latch misaligns seasonally. The gate post is settling independently of the line, or the hinge was mounted without shimming for the natural cross-slope. Stevenson Ranch and Sand Canyon lots with 4-6 percent grades see this constantly.
- Corrosion at the post base, even on aluminum. Galvanic reaction between the aluminum post and the steel anchor bolt, or trapped moisture against the concrete collar. The white, crusty buildup is aluminum oxide; left alone, it will wallow out the post wall.
Before
AfterReplacement Cost & What’s Included
| Scope | Price Range in Santa Clarita |
|---|---|
| Single post replacement (footing, post, cap) | $350-$650 |
| Rail section repair (2 rails, 6-8 pickets, hardware) | $450-$850 |
| Partial panel replacement (up to 8 ft, matching existing) | $700-$1,400 |
| Complete Boral fence installation, 100-150 linear ft | $3,500-$9,000 |
| Gate rebuild on existing posts | $600-$1,200 |
What drives the range: footing depth in hillside Santa Clarita soils, whether we need to match a discontinued Boral color, and access for concrete work. Every quote is flat and written before we start, per Clause 1 of The Haven Standard. The price includes parts, labor, permits if required by your HOA or the city, and haul-away. Our 365-Day Done Right Promise covers the workmanship; Boral’s finish warranty covers the coating. You’ll receive a documented photo record of the footing excavation, post plumb, and final alignment before we leave.
DIY or Call Us?

There’s no high-tension danger in fence work, but there is a long list of ways to build yourself a recurring headache. An owner can safely check whether a post is plumb with a 4-foot level, confirm the footing diameter by scraping back soil, and photograph the chalking for a warranty claim. Where DIY goes wrong is in the details that don’t show up for two years: concrete mixed too wet that crumbles, post depth 4 inches shy of frost line equivalent for wind load, rail expansion gaps omitted because they look sloppy on day one.
We’ve rebuilt enough homeowner fence jobs in Santa Clarita to recognize the pattern. If you want to verify the problem yourself, we’ll tell you what to measure. If you want it fixed so you don’t think about it again, call (747) 294-3985 for a written estimate.
FAQs
The aluminum structure typically lasts 25-30 years; the powder-coat finish shows visible UV chalking at 7-10 years in our high-sun climate. You can recoat rather than replace if the substrate is sound. Call (747) 294-3985 and we’ll assess whether recoating or replacement is the honest recommendation.
A bent rail cannot be straightened to factory spec; the kink creates a stress riser that will re-bend. Cracked rail ends or pulled pockets require replacement of that rail section. We stock 6-foot and 8-foot Classic and Estate rails for same-day repair in most cases.
Post replacement with concrete cure time is one day; full residential installation of 120 linear feet is typically 2-3 days, plus permit lead time if your Santa Clarita HOA or the city requires one. We handle permit submittal and inspection scheduling as part of the scope.
We stock Classic and Estate rails, posts, and standard pickets for heights up to 6 feet. Custom colors or 8-foot heights typically pull from Fontana within 48 hours. We’ll confirm stock against your series and color before you sign the quote.
Rowan Construction Group Santa Clarita is an independent service provider and is not affiliated with Boral. We also stock and install parts for KraftMaid, Cambria, and Silestone products across our seven trades.
Ready for a written price? Call (747) 294-3985 to schedule your free estimate. We’ll measure twice, document once, and build it right the first time.
Written by Grant Rowan, Owner, Rowan Construction Group Santa Clarita at Rowan Construction Group Santa Clarita, serving Santa Clarita and nearby areas.







Before
After
Before
After